Picture Banner for SECC K12 Site

Southeast Frosts & Freezes body

What’s the difference between a frost and a freeze?

Frost forming on plants

Figure A

Although people use frost and freeze interchangeably, they actually mean two different things. The National Weather Service issues frost advisories and freeze warnings during the growing season if they expect temperatures to dip around or below freezing. When they issue a frost advisory, air temperatures are typically above freezing but frost is possible at the ground, especially when the humidity is high. This can be hazardous to tender vegetation that is sensitive to frost. When the National Weather Service issues a freeze warning, temperatures are expected to fall below 32oF for the region, ending the growing season for most plants by destroying the leaf structure of the plants as the water inside the leaves freezes and expands.


What kinds of conditions are needed for frosts and freezes?

Temperature inversion

Figure B: Temperature Inversion with Radiation Fog

Typical conditions needed for frost are clear skies and very light winds (this kind of frost is called radiation frost) as any heat at the earth’s surface can re-radiate back to space, allowing optimal surface cooling. During a radiation frost, temperatures above the surface are typically warmer than the temperature of the air at the surface, leading to what we call an "inversion." The inversion is not very deep, however, as it can range from 30-200 feet. If the temperature at the earth’s surface is the same as the dew point and they are both below freezing, frost will form. If the air is dry, it is possible to have temperatures below freezing and not have frost.

Example of an Advection Freeze

Figure C

The most common kind of freeze that occurs is an advection freeze. An advection freeze is caused by cold air moving from one region to another. Unlike radiation freeze events, advection freezes typically have some wind (sometimes strong wind) and there can be clouds in the sky.  However, freezes can also occur in clear, calm conditions when the temperature drops sufficiently after sunset across a wide area.


Are there ways to prevent frost/freeze damage to crops?

A wind machine "breaking" an inversion layer

Figure D

Although frost and freeze damage to crop plants can be negative and irreversible, there are some measures which can be taken in order to protect high-value crops.  While there is not one solution that is guaranteed to protect crops, farmers have developed ways to increase the chance of plants not getting harmed by cold weather. Below is a list of popular methods used by farmers.


As the name implies, heaters can create heat and raise the temperature in the surrounding area. Most heaters are designed to run on oil for fuel, and due to the rising costs of oil, many farmers have looked for other alternatives. Heaters work well in both radiation fog and advection freeze conditions.

Fans/Wind Machines

These work extremely well during radiation fog events. As mentioned earlier, during radiation fog, an inversion forms where temperatures increase with height. When a fan is used in this event, it mixes the air at the surface with the air above, and temperatures at the surface become warmer as the warm air above is pulled down. If a hard freeze or frost is expected that night (temperatures below 28 degrees F), heaters can be used in combination with fans to create a warmer environment. However, in the event of an advection freeze, fans typically are not beneficial. The wind is blowing during an advection freeze and there is no inversion to mix. Occasionally helicopters are used to keep the air mixed in order to save the crop if the inversion layer is present. Wind machines and helicopters can be very expensive to use in the event of a freeze warning, but saving the overall crop is worthwhile in the end, especially if the grower owns thousands of acres of land. Hundreds of thousands of dollars can be lost due to freezes.


Although this method can be dangerous to use, it actually can work well if used properly. Compared to using wind machines and oil heaters, irrigation is a much cheaper method to use. When water freezes and turns into ice, it releases latent heat. Then, the ice that builds up on the plant will insulate it from the colder surrounding air temperatures. Because of this, some growers choose to spray their crop with water before the freeze occurs.

Sprinklers protecting blueberry blossoms from frost in early spring.

Figure E: Frost Protection on Blueberry Bushes
Image from http://www.nelsonberryfarm.com/aboutus.htm

There are some problems with the irrigation method. Usually, farmers use sprinklers to spray water on their plants and crops. If too little water is applied, there won’t be enough heat released by water to keep plants protected. If too much water is applied, then the soil becomes waterlogged and can hurt the plant's roots. Additionally, if too much water freezes on the plant, the weight of ice can snap or break limbs. The solution to this is to use automated sprinklers that water periodically throughout the night.

Farmers in Florida used the irrigation method to protect their crops from a hard freeze in 2002. Temperatures near Tampa, Florida, dropped down to 28 degrees for three straight hours before rising again. The irrigation method kept the plants insulated during the coldest hours of the night, and although there was minor damage to smaller plants and blossoms, no major extensive damage was reported.

Row Covers

Row covers, when placed over delicate crops such as strawberries, can raise the air temperature several degrees above the air temperature outside of the row covers by reducing radiational cooling.  This can prevent a frost event if temperatures hover around 32oF. 

Last modified date: Wednesday, August 8, 2012 - 2:27pm